Please ensure the product(s) that you are going to buy fits the brand, model and part number of your device.
You will be required to install a non-hazardous program to ensure the battery be 100% compatible with your laptop. This program will update the underlying device driver of intelligent lithium battery, including the BIOS. Please read the instruction manual carefully before you start to install the program.
The package includes 1pc battery and 1pc CD. The program in the CD might not be latest version. Please send email to our customer service, tell us the Order No., so as to get the latest version's program.
>> Download the Instruction Manual
This replacement SONY VGP-BPS13AS Laptop Battery can replace the following part number:
A new SONY VGP-BPS13AS battery comes in a discharged condition and must be charged before use (refer to the devices manual for charging instructions). Upon initial use (or after a prolonged storage period) the SONY VGP-BPS13AS may require three to four charge/discharge cycles before achieving maximum capacity. New SONY VGP-BPS13AS battery needs to be fully charged and discharged (cycled) a few times before it can condition to full capacity. Rechargeable batteries undergo self-discharging when left unused. Always store a battery pack in a fully charged staged for storage.When charging the SONY VGP-BPS13AS battery for the first time the device may indicate that charging is complete after just 10 or 15 minutes. This is a normal phenomenon with rechargeable batteries. Remove the batteries from the device, reinsert it and repeat the charging procedure.
It is important to condition (fully discharge and then fully charge) the SONY VGP-BPS13AS battery every two to three weeks. Failure to do so may significantly shorten the battery's life (this does not apply to Li-ion batteries, which do not require conditioning). To discharge, simply run the device under the battery's power until it shuts down or until you get a low battery warning. Then recharge the battery as instructed in the user's manual. If the battery will not be in use for a month or longer, it is recommended that SONY VGP-BPS13AS battery be removed from the device and stored in a cool, dry, clean place.
Invest in a good charger for your device. Ni-MH batteries should not be charged in a NiCad charger, unless the charger is specifically made for both chemistries. There are cheap chargers and there are expensive chargers. Make sure the charger you get has good reviews and is well made. Chargers with micro-controller chips are usually the best choice of your device.
Be sure to store your battery properly. Do not leave your batteries in a hot car, or in humid conditions. The best storage conditions are a cool, dry place. The refrigerator is fine if you stick in a packet of silica gel with your SONY VGP-BPS13AS battery in a sealed bag to keep them dry. It is a good idea to charge your NiCad or Ni-MH batteries fully before use if they have been in storage.